Leave feedback
  • Question

    AFP Driver

Enter a new topic
  • Andrés Cheda Andrés Cheda
    0 likes 158 views

    Hello,

    After migrating a project, which generates AFP, from StreamServe 5.3 to 5.6.2., the printed results have changed, now the LXF lines included in the documents are printed finer than in the previous version.

    I attach the configuration of the AFP driver in the two versions.

    Can it be achieved by configuring the driver that the lines of the LXF are printed thicker?

    Any ideas?


    Thank you very much.

    One week ago
  • Vyv Lomax Vyv Lomax Administrator
    1 likes

    Hi Andrés, there are clear differences on between your driver settings on the Before Job level. Please try to synch the settings and check for better results. E.g. Line Thickness Factor 100/120.

    Walk through each setting and check it off against the previous version.

    Good luck!

    One week ago
  • Andrés Cheda Andrés Cheda
    0 likes

    Hi Vyv, thank you very much for your reply. I have change the value to Line thickness paremeter (120) to try that the LXF lines it was more thickner than in the old version, but that parameter dont cause effect in lines (as it says in the documentation "The line thickness factor applies to polygons only – not to lines and boxes."). What I'm looking for is to be able to adjust the lines also so that they appear wider when printing.

     

    Thanks a lot and best regards.

    One week ago

 

Latest from the blogs